bergermaister
04-05-2011, 11:51 AM
Upgrade time so selling my Kicker ZX 350.2 amp. I used this to power my tower speakers - 4 polk audio 6.5" wired in parallel for a 2ohm load and they hit hard and clear.
Asking $120. I may split or pay for shipping depending on where you're located.
Manufacturer specs are:
• 2-channel car amplifier
• 110 watts RMS x 2 at 4 ohms (175 watts RMS x 2 at 2 ohms)
• 350 watts RMS x 1 in bridged mode (4-ohm stable in bridged mode)
• variable high- and low-pass filters (50-200 Hz, 12 dB per octave)
• variable bass boost (0-18 dB at 40 Hz)
• wired remote bass level control
• top-mounted controls
• CEA-2006 compliant
• speaker-level inputs
• preamp inputs and outputs
• fuse rating: 25A x 2
• 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• 13-1/2"W x 2-5/16"H x 9-5/8"D
http://i326.photobucket.com/albums/k414/grberglund/P1060826.jpg
http://i326.photobucket.com/albums/k414/grberglund/P1060827.jpg
http://i326.photobucket.com/albums/k414/grberglund/P1060828.jpg
http://i326.photobucket.com/albums/k414/grberglund/P1060824.jpg
Asking $120. I may split or pay for shipping depending on where you're located.
Manufacturer specs are:
• 2-channel car amplifier
• 110 watts RMS x 2 at 4 ohms (175 watts RMS x 2 at 2 ohms)
• 350 watts RMS x 1 in bridged mode (4-ohm stable in bridged mode)
• variable high- and low-pass filters (50-200 Hz, 12 dB per octave)
• variable bass boost (0-18 dB at 40 Hz)
• wired remote bass level control
• top-mounted controls
• CEA-2006 compliant
• speaker-level inputs
• preamp inputs and outputs
• fuse rating: 25A x 2
• 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
• 13-1/2"W x 2-5/16"H x 9-5/8"D
http://i326.photobucket.com/albums/k414/grberglund/P1060826.jpg
http://i326.photobucket.com/albums/k414/grberglund/P1060827.jpg
http://i326.photobucket.com/albums/k414/grberglund/P1060828.jpg
http://i326.photobucket.com/albums/k414/grberglund/P1060824.jpg