View Full Version : Platform Sizes by Year for Sea Dek Pads
03-10-2011, 11:23 AM
The intent of this thread is to allow folks to post up platform sizes by year and model. The hope is that we can figure out which years and models have more than one size and which years have consistent size on each model. The goal is to make info available to those who wish to order new pads in the offseason and do not have access to their boats to get their own measurements. When sufficient information has been posted to draw conclusions I will attempt to make a chart to make it easier. Obviously, there is no guaranty of accuracy but in the odd event you end up with the wrong size pad you can always post it in the classifieds.
Please post your year, model and measurements, even if you already see that year and model posted. Thanks to all for their input to try to help our Moomba brethren!
03-10-2011, 12:18 PM
The seadeck pad on my boat measures 69" across the width right up against the transom and tapers as it gets further away from the boat. The pad measures 23 1/4" in the middle.
03-10-2011, 01:47 PM
I was out there a little while ago. I did not measure the pad, I measured the platform itself off the boat. From tip to tip on the widest edge (that would be up against the boat) it measured 69 1/2". Then placing a straight edge across the longest side, I measured from the center of that line back to the opposite edge and it was 26 1/4". The center width of the platform itself measured 24".
Sorry for crude image but this should help:
03-10-2011, 03:18 PM
I would say our platforms are the same size then.
04-07-2011, 07:57 PM
So Based on the SeaDek website on my 08 LSV if I buy the 3 piece roo pad measuring 69 1/16 by 25 7/16 would be the right replacement transom pad.:D
06-28-2011, 02:58 PM
2003 Moomba LSV
69 3/16 x 25 9/16 inches Seadek Swim Platform Pad
06-28-2011, 03:18 PM
2005 Mobius LS
69 3/16 x 25 9/16 inches
Powered by vBulletin® Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc. All rights reserved.