View Full Version : How far should the Wake plate go down?
08-26-2010, 06:15 PM
does the wake plate level out with the boat or does it extend down pass the streamline of the boat. Is there an oil level I have to check for the wake plate and any other maintainance? thanx
STANG KILLA SS
08-26-2010, 06:29 PM
if i recal the plate BARELY goes below parrellel with the bottom of the hull. most of the movement is up.
theres no oil. they are electronic actuaters, not hydrolic cylinders.
08-26-2010, 11:35 PM
Stang Killa is correct, it barely goes past parallel. On my '07 however they are electric/hydraulic actuators with a fluid tank mounted behind the rear bench in the engine bay.
08-26-2010, 11:55 PM
My 08 uses 2 hydraulic cylinders, and probably drops 15 degrees below level. 09 and up switched to a single electric actuator.
Powered by vBulletin® Version 4.2.3 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.