pulling the floor in OBV07

[jmvotto]

Has anyone one pulled the floor in an 06 to 08 OBV or a pre-06 lsv. Is it a one man job? or will i need two people to help get the floor out. It may be awkward but i think i should be able to get it. Ballast project her i come....:rolleyes:

[mcdye]

i recall some threads conerning replacment of the steering cable and it was 2 man job to lift it out.

[2007 Outback V]

Why do you need to pull the floor? It is not that hard to do, but it would be nice to have an extra hand to lift it out.

[jmvotto]

GI to GIII upgrade, the oem wiring harness is not long enough to go around the side walls

[NCSUmoomba]

Is that even possible? In my boat, the floor is bonded to the hull and is not removeable. The only parts I can remove are the parts screwed down.

[cab13367]

GI to GIII upgrade, the oem wiring harness is not long enough to go around the side walls

Joe,

On my boat, there are two panels and it's easily a one person job. Not sure about yours though.

Al

[Sharpie647]

I pulled my floor in my 02 lsv. Took two of us. maybe this thread would help

https://forum.moomba.com/showthread.php?t=3946&highlight=cable

[VA LSV]

There are screws in the edge of the floor in addition to the chrome ones you see in the carpet. I didn't know about them when I upgraded from GI to GIII so I ran the OEM wiring harness around the drivers side.

[moombadaze]

pulled the floor in my 03 lsv myself. not that hard at all. Just those screws hidden under the rear seats were a pain