View Full Version : wakeboard rope ?
jmvotto
08-09-2010, 10:38 PM
what is the plastic sleeve that goes over the rope for?. I have a roped and it got all knotted up so the plastic sleeve is creased,cracked etc. can i just remove it.
:?:
viking
08-10-2010, 12:16 AM
i think it's to protect the board when getting pulled up?
brain_rinse
08-10-2010, 12:31 AM
I like the coated because it keeps rope burn to a minimum. I know there are high quality uncoated lines too, but I'm not sure if they are the same as a coated line with the coating removed.
Ian Brantford
08-10-2010, 10:54 AM
It keeps the rope from forming a loop anywhere near the rider in case of slack during a crash. It won't get wrapped around a limb. I'd say that it's time to make that your backup rope and get a new primary rope.
jmvotto
08-10-2010, 10:55 AM
Dan, you must be doing some tricky stuff. I am justr doing w2w and switches. so hopefully removing the coating thats all friqued up wont hurt too bad.
brain_rinse
08-10-2010, 11:16 AM
Dan, you must be doing some tricky stuff. I am justr doing w2w and switches. so hopefully removing the coating thats all friqued up wont hurt too bad.
:) No, just rope burn from when the boat driver is dragging the handle to me.
jmvotto
08-10-2010, 11:39 AM
:) No, just rope burn from when the boat driver is dragging the handle to me.
gotcha....
ditto on the rope burn, and it's great for not getting knots in your rope... but it also make it much harder to cut.
I got one wrapped around the prop, and it took forever to cut through it. Of course, that was with a pocket knife.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.