blower switch plate ??

[jmvotto]

My blower switch plate face popped off. Any ideas how to get it back on? It does not look broken, but when i push hard it does not snap on, i am afraid to push really hard and break the panel.

any suggestions?

[cab13367]

My blower switch plate face popped off. Any ideas how to get it back on? It does not look broken, but when i push hard it does not snap on, i am afraid to push really hard and break the panel.

any suggestions?

Joe,

I recently changed a ballast switch faceplate to a heater faceplate and I don't remember anything special about installing the new switch. I think there are two tabs, one on each side of the switch that just snapped in. Maybe u don't have the tabs lined up right??

Al

[jmvotto]

Al, not the whole switch just the cover on the switch....

[cab13367]

Al, not the whole switch just the cover on the switch....

Yes, cover, facepate, same difference :) I changed only the cover as well. Did u get it back on?

[jmvotto]

Not yet, it wont snap back into place looks like a little piece is missing for the snap on, i could probaly use a little silicone or gorilla glue on the center stud to adhere it.