Activity Stream

At what temp does the heater start blowing warmer air? New to inboards, too.

Around here, we have many Automotive alternator and starter repair shops. Lower amp alternators are likely cheap enough to replace from the auto...

I bet they work fine. I bet the earlier comment where you said the tech told you the old ones had probably deformed over time is correct. The new...

Just search for electric motor repair shops. Or call some HVAC companies/electrical contractors and ask about them. Sent from my SM-G781V using...

Man I bet that was a blast! He will remember that and be stoked for going back again! Sent from my SM-G781V using Tapatalk

Yes Harf and Murray. They did a couple passes together throwing some big stuff for the kids. And i can't figure out how to post the full page...

Got the boat washed last weekend. Also spent the past week wiring in a second battery and installing an amplifier..QUOTE] Love your all black! Not...

I personally would find a local shop. Typically the voltage regulators fail before the windings get damaged. Bearings are probably fine. Sent...

Went to the thigh high wake competition in Orlando yesterday. My son really loved it and had a blast riding the cable park and hitting the ramps. ...

About the Glide dripless seal. 1.125 shaft any idea what length you ordered? I'm not sure where to take the measurement on the old unit.

Probably not a bad idea. Any thoughts on where to go with it? Something I have done locally or send it off? Sent from my iPhone using Tapatalk

Hay H yep it definitely fixed on the mounted end and pivots on the plate end. So it probably does flex at the fixed end. I’m going to just throw them...

I would check what that 230 amp alternator would cost to rebuild as a back up. Sent from my iPhone using Tapatalk

I opened the pdf and see what you mean now. Still don't like that design. Constantly flexing plastic will eventually fail. Not to mention it...

Wow. That's really not a very good design. Sent from my SM-G781V using Tapatalk

No pin. It flexes.

Glad it is working without too much trouble. Now put it in the water and have some fun! Sent from my SM-G781V using Tapatalk

Exactly. It has to either pivot or slide or it just won't work. The angle of the actuator has to be able to change as it moves. That's why the...

The upper part attached to the transom is the upper hinge. I had 1 leaking and rebuilt both of mine after Bennett sent me the kits. Kit comes with...

Thanks! Full day on Belews lake tomorrow. Will report back on results.

Yeah the dripless seal is acting like a dripping packed seal. There is water coming out of the front in the hull. I know it is supposed to drip...

This is the coupling separator you will need, plus a few hefty wrenches because the shaft really doesn’t want to come loose!

So water was dripping under the boat from the shaft? That would be normal, it’s water cooled. If you mean in the boat water was coming in from...

Some more sesrching....radio is most likely dead...upgrade to RA210 or something else? Dripless seal doesn't look horrible to change. Anyone that...

Looks good! Is that a wrap on it? I keep my mondo at my grandfathers house which is for sale currently. Had some folks come to look at house and...

I like that paint scheme on that Mondo. Sent from my SM-G781V using Tapatalk

The Amazon foam works. The boat is really quiet. Lost a couple small squares over winter storage, but the large pieces stay put. I rate...

Thanks everyone! I was 98% sure that it was an Oz tower, but the little info on the V2 I found wasn't as definitive as I was hoping!

Put a deposit on this 17 Mondo last weekend