Activity Stream

Probably not a bad idea. Any thoughts on where to go with it? Something I have done locally or send it off? Sent from my iPhone using Tapatalk

Hay H yep it definitely fixed on the mounted end and pivots on the plate end. So it probably does flex at the fixed end. I’m going to just throw them...

I would check what that 230 amp alternator would cost to rebuild as a back up. Sent from my iPhone using Tapatalk

I opened the pdf and see what you mean now. Still don't like that design. Constantly flexing plastic will eventually fail. Not to mention it...

Wow. That's really not a very good design. Sent from my SM-G781V using Tapatalk

No pin. It flexes.

Glad it is working without too much trouble. Now put it in the water and have some fun! Sent from my SM-G781V using Tapatalk

Exactly. It has to either pivot or slide or it just won't work. The angle of the actuator has to be able to change as it moves. That's why the...

The upper part attached to the transom is the upper hinge. I had 1 leaking and rebuilt both of mine after Bennett sent me the kits. Kit comes with...

Thanks! Full day on Belews lake tomorrow. Will report back on results.

Yeah the dripless seal is acting like a dripping packed seal. There is water coming out of the front in the hull. I know it is supposed to drip...

This is the coupling separator you will need, plus a few hefty wrenches because the shaft really doesn’t want to come loose!

So water was dripping under the boat from the shaft? That would be normal, it’s water cooled. If you mean in the boat water was coming in from...

Some more sesrching....radio is most likely dead...upgrade to RA210 or something else? Dripless seal doesn't look horrible to change. Anyone that...

Looks good! Is that a wrap on it? I keep my mondo at my grandfathers house which is for sale currently. Had some folks come to look at house and...

I like that paint scheme on that Mondo. Sent from my SM-G781V using Tapatalk

The Amazon foam works. The boat is really quiet. Lost a couple small squares over winter storage, but the large pieces stay put. I rate...

Thanks everyone! I was 98% sure that it was an Oz tower, but the little info on the V2 I found wasn't as definitive as I was hoping!

Put a deposit on this 17 Mondo last weekend

Got the boat washed last weekend. Also spent the past week wiring in a second battery and installing an amplifier.. Sent from my iPad using...

Boat look great!! Congrats! Sent from my iPhone using Tapatalk

So a little update got the new alternator put in and 14.1V at idle so much better!! Thanks for all the input! Sent from my iPhone using Tapatalk

I don't think you can just unbolt the battery from the alternator and start the boat. I think its circuitry requires the battery and alternator to be...

Yup you can drop plenty of crate engines, or even low mileage used engines, main thing to replace is get a Marine Rated Starter and Alternator.

iBoats WestMarine Greatlakes Marine all sell them

OR. Is there a sliding mechanism or slot that is on the end where it mounts to the wake plate? Sent from my SM-G781V using Tapatalk

The main difference in the OZ towers was the Tower Tube Diameter, the V2 was the first tower that was not a tube tower, I want to say it looks...

Out of fairness, it was quick release Rev 10s and and bimini that was held on by two thumb screws and a strap. I’ve seen plastic speaker housings...

For those of you wanting a Surf pipe you have the option to goto Fresh Air Exhaust and get one for your boat. I had one of my 08 when the FAE was...