Activity Stream

The weird thing is at 2000 rpm’s temp went to 169. I backed it off to idle and it dropped to 165 and then raised all the way up to 171 while...

Changed the thermostat, checked the idler pulley and the raw water impeller. I thought I had the impeller in backwards at first and changed it...

I dug out the old flax packing. There were two pieces one was destroyed and in tatters. The other was in decent shape, but I think I over tightened...

I had a guy in the boat tonight recording sound. When I shift from neutral it makes a sound. He said it’s coming from the back and thinks it’s the...

Checked the shaft packing, all good. I recall in the past overtightening the nut and it zinged on the shaft. I only hand tighten now to a slow drip...

I check the impeller a few times a year. All the 'fingers' are there and it seems to be pumping well. Temp stays around 160. Packing seal I adjusted...

You figure you run these engines at 3200rpm or higher for hours at a time. In the truck, at cruise speed, the transmission would drop to overdrive...

Got it. Thanks. I think I saw your post on the idler pulley and replaced 2 of 3 wheels last year. I did not realize there was a 3rd until I got...

It's the same 160* thermostat for a 6.2 ford 150 raptor truck. There is not a marine version. Also, check your idler pulley. Mine locked up and...

Your fill sensors need reset and/or calibrated. You are over filling and the sensors are not shutting them off. My 2015 didn't have these and you...

If it is random and happens at any engine condition, then most likely not engine related. When did you last replace your raw water impeller? Hard...

Do you happen to have the part number for the thermostat you bought? Mine got to 215 today and threw a code “ETC higher than expected stage 1”. I...

Try this. Shut it down and turn off the battery switch and let sit for 10 minutes. Turn battery switch to 1 or 2 not both. (My 2015 I would...

I found the other thread with folks having similar problems. Maybe it’s true you have to let the computer cycle through before hitting the starter. I...

I think holdmybeer is right, usually a software issue. You could possibly have the dealer update your software to a newer version.

Thanks, I will call dealer tomorrow. Couldn’t find others on this forum with the problem. Most problems had to do with the Autowake system, which I...

Being the the forum long enough, I believe several have had this problem. Dealer trip for firmware update and all was good again.

Our old 2015 Mojo was so small parked side by side. It feels bigger when driving also but so much smoother. Going from old surf system and 3...

Great pictures. We don't take our dogs on the boat a lot but it is fun to have them on when we do. If buffing with a heavy compound did not...

beautiful boat! There is a newer mojo that frequents the lake we go too and we parked next to them at the beach a couple of weeks ago. They're so...

She's in your city and she's ready - No Selfie https://GirlSingle.com Girls who are ready to meet you NEW GIRLS Addison Gray ...

Since you started the thread, I figure I would reveal my new ride. 2025 Mojo. Thrusters, fat guy step, etc. Only option I didn't get was the power...

Is there a torque spec for the shaft to coupler nut and also the couple to couple bolts?

And also lost the “A” in Moomba on one side so I decided to strip it all off and go for a naked look. Didn’t turn out quiet like I planned as it...