Activity Stream

Season started for us today! Got it washed, waxed and in! Sent from my iPhone using Tapatalk

We normally skip holiday weekends but wife and I had the day to ourselves without our daughter so off to the lake we went. We just grabbed a slough...

Went out yesterday and surprised that it wasn't near as busy as I expected out there. Got some foiling and surfing in. Wife got to try her new board...

That tool was worth the $40 several years ago. It has also netted me lots of free beer for helping.

Under the port side locker is a 12v bus lug and ground lug that the amps use. They come straight from the battery switch and would be where I would...

Under that cover on the bottom left of the dash is just a usb outlet and an aux cord for the stereo. Maybe I’ll have to go the route of alligator...

This took about 2 minutes.

I’ve always had better success with the inflators that clamp onto battery terminals. The one we have now can blow up a 5-person banana boat in about...

I believe it is on the bottom left side of the dash, to the left of the surf switch. I think it has a cover on it.

Fantastic. Thank you. I started in a few times today and the code did not appear. 2003 Outback 2007 LSV 2016 Craz Sent from my iPhone...

Actually I am wrong here. The replacement pump is a Jabsco Puppy 18670 series - 8-9 GPM. They are $385 and discontinued. Wakemakers is selling...

Low oil level. If you had your key on while changing oil it triggers it. Like myself most people have the radio on while doing maintenance. If...

or this one. ...

Where are they 200? I'm seeing 270 on wakemakers. https://www.wakemakers.com/products/jabsco-ballast-puppy-wakeboard-pump

The windings are shot. Not worth rebuilding. New one is $200, and I never have seen a rebuild kit for the motor.

The shaft spins by hand, just not when plugged in and getting power applied to it.

Any debris blocking impeller? I would see if you can try and break it free with a pair of pliers. Sent from my iPhone using Tapatalk

thank you broo.ç

It will fit jist fine. You only have a single strut verses the double strut of the newer boats. You can either cut a groove in the front and make...

Ordered mine today - wow they have gone up! $272 from local dealer. I will be the first 2014 fitting one but if measurements are correct that I see...

1 vote for groove #2.

Ok thought so too after looking at the filter housing. (thanks for that edit! ;-) I was questioning myself deeply) If I recall, when I initially...

Groove 1 is correct. Although, looking at the design, groove 2 likely would seal it as well. Sent from my iPhone using Tapatalk